TeachMeFishing

Learn the Skills · 2 min read

How to Put New Line on a Spinning Reel

How to tie line to a spinning reel spool with an arbor knot, spool it without twists and how full to fill the spool.

Close-up of weathered hands tying a fishing knot in clear line, with a spinning reel and orange bobber nearby

If your combo didn't come with line, or your old line is worn out, you'll need to spool new line. It takes about ten minutes.

1. Tie the arbor knot

  1. Open the bail (the wire arm) on the reel.
  2. Wrap the line around the spool.
  3. Tie a simple overhand knot with the tag end around the main line.
  4. Tie a second overhand knot in the tag end to act as a stopper.
  5. Pull the main line so the knot slides down and cinches against the spool. Trim the tag end and close the bail.

2. Spool without twists

Lay the new line's spool flat on the floor with the label facing up. Line should come off the filler spool in the same direction it goes onto the reel. Hold the line between your fingers with light tension and reel slowly. If the line starts twisting, flip the filler spool over.

3. Don't overfill

Fill the spool to about ⅛ inch below the lip. Too much line causes loops and tangles; too little shortens your casts.

4. Run it through the guides

Thread the line through each guide on the rod, starting at the one nearest the reel, and tie on your hook.

Updated November 18, 2026. Fishing rules vary by state; check your state wildlife agency's current regulations.